Baffles

There are two kinds of baffles:

• directional baffles
• safety baffles

A directional baffle is a solid metal plate whose purpose is to direct heat and flames into a specified direction. The directional baffles could be installed vertically, horizontally or a combination of the two. Directional baffles are used most often in wood stoves. Directional baffles are presented in the chapter on fire pits.

A safety baffle, commonly used in one unit smokers, is a perforated metal plate that separates the firepit from the meat compartment and its main purpose is preventing flames from reaching the smoke chamber. Better designs advocate the use of two or three baffle plates separated by 3 - 4 inches, though that complicates the smokers construction and steals the valuable space.

Baffles are a very important design feature of any small smoker with a firepit located in its bottom part as they safeguard products from flames and wild jumps of temperature. They provide a piece of mind when smoking making the entire process more organized and controlable and they also help to disperse smoke slowly and evenly to all parts of the smoking chamber. If a smoker is connected by a pipe with a separately standing fire pit, the baffles are not necessary.

Meat hangs in different sections of the chamber but the smoke pouring out of the pipe, or the one raising up from the fire pit is using the path with the least resistance and that means it is rushing straight up. A baffle puts some brakes on the smoke forcing it to slow down and disperse evenly in all sections of the drum. During cooking the baffles will slow down the heat escaping straight up and the design of the smoker will be more efficient.

A baffle is a perforated metal plate, rectangular or round, of about 1/8” (3 mm) thickness or more, strong enough to support the weight of river gravel or another baffle. Its diameter should be about 2” (5 cm) smaller than the diameter inside of a barrel to facilitate removal for cleaning. The holes between ½ - 1” ( 12 – 25 mm) diameter should be drilled at random so if the two baffles are used, there will be some offset between holes for better smoke distribution.

The smoker will work even better when a second baffle is installed. The bottom baffle will rest freely on three right angle metal supports secured to the barrel with bolts and nuts and positioned every 120 degrees. The top baffle will also rest freely on three spacers, about 4” high and also placed every 120 degrees.

Fig. 10.19.1 Single baffle smoker		Fig. 10.19.2 Two baffle plates with spacers